Choosing good hydraulic oil has a big impact on Hangzhou filter machine

The hydraulic system of Hangzhou filter machine has a hydraulic station that pumped and store oil. The storage space of the hydraulic station is also very limited, so it is necessary to add a suitable hydraulic oil to the hydraulic station. Under normal conditions, the amount can be about 85% because the volume is large, and the amount of oil will directly affect the normal operation of the hydraulic station. The oil in the hydraulic station shall not be less than 40% because the amount of oil will affect the pumping of the internal pump. Therefore, in daily life, it is necessary to regularly check and maintain hydraulic stations. The hydraulic system of the Hangzhou filter machine is very important to the entire system. Choosing a good hydraulic oil has a great impact on the plate frame filter machine.

press filter

Hydraulic oil can provide powerful pressures for a filter machine. If you want the filter machine to work, you need powerful pressure. When choosing hydraulic oil, consider a variety of factors, choose abrasion resistance and pressure resistance. The pipelet oil leakage of the Hangzhou filter machine is usually due to frequent use of the filter machine and the vibration of the machine. The lower portion of the pipe connection is connected to the cylinder through a combined gasket. The inside of the pipe is connected to the O-ring. Remove the filter tube, loosen the tubing, then remove the tubing joint to replace the combination gasket. When replacing the combined washer, please replace the O-ring at the same time. When the edge of the filter machine is damaged, even if it is slightly lifted, the side surface is often worn. Moreover, it is in contact with other filter plates, regardless of the pressure, the resulting filter chamber penetrates. In this case, we judge the penetration of the filter plate from the leak point, and can even spray it. The filter cloth is not placed correctly. There are many reasons why the filter chamber cannot be sealed. We need to start from a simple filter chamber to see if the filter cloth has a wrinkle or filter cloth edge. Since the structure of the filter chamber is located between the filter plate and the filter cloth, the filter plate is usually less likely to occur, and the remainder is the filter cloth. A seal is formed between the rigid filter plates to play a key role in the filter cloth. Wrinkles or defects in the natural filter cloth may cause the gap between the filter plates, and the natural filter chamber does not form a seal. Insufficient pressure. The filter plate and the filter cloth are subjected to a large amount of pressure to achieve a closed filter chamber structure. When the pressure is insufficient, the pressure applied to the filter plate is smaller than the pressure of the filtrate, and the natural filtrate can be considered justified.